![]() If programming is unsuccessful, the keypad will fl ash red three times with three beeps. The keypad will flash green and you will hear three beeps. For instuctions on how to add user codes when the Mastercode is disabled, see the Installation and User Guide that came with your lock. The procedure for adding user codes is different when the Mastercode is enabled. Note: The lock will time out after five seconds.Īdding User Codes with the Mastercode Enabled If you hear three beeps and see the keypad flash green, the Mastercode is enabled. Make sure switch #3 is on, and press the Program button once.Attempt the procedure again, making sure to enter the same new Mastercode in step 2 and 4. Make sure the Mastercode has not already been programmed. ![]() If programming is successful, the keypad will flash green once with one beep. Press and HOLD the Program button until the keypad flashes green (about 5 seconds). Programming timeout: If no button is pressed for five seconds, the system will time out (indicated by three beeps and a red flashing keypad), and you will need to restart the procedure. A Mastercode is used to add and delete user codes, but it cannot unlock the door (unless the same code is programmed as a user code, though this is not recommended). Using a Mastercode is an optional, added-security measure. 5.2 The batteries drain within one week.5.1 The batteries drain within one day.4.2 The Lock button does not lock the door.3.4 The deadbolt latch does not extend or retract on its own during the door handing process.3.3 The Status LED is solid red after the door handing process.3.2 The lock beeps, the keypad flashes red, and the door cannot lock.3.1 The lock jams and the turnpiece does not rotate smoothly.3 Troubleshooting: Door Jamming and Door Handing.2.3 The interior assembly does not fit on the mounting plate.2.2 The interior and exterior assembly won't mount parallel to the door edge.2.1 The interior mounting screws are difficult to tighten.1.6 Disabling and Deleting the Mastercode.1.5 Deleting All User Codes with the Mastercode Enabled.1.4 Deleting a Single User Code with the Mastercode Enabled.1.3 Adding User Codes with the Mastercode Enabled.1.2 Enabling and Setting the Mastercode.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |